Table of Contents

Shenzhen Maiyongchao Technology Bluetooth headset User Manual

AIR CONDUCTION HEADPHONES WIRELESS HEADSETS

Power on/off

Power on: Open the headphone compartment and take out the headphone to enter the matching state automatically; (Manual power on)Press and hold the button for about 3 seconds, the white-orange light will flash for 200ms, turn off after connection, and the voice prompts “power on”.

Power off: Headset into the charging compartment into the charging state automatically shut down and disconnect; (Manual shutdown) Press and hold the button for about 5 seconds, the orange light will be on for 3 seconds, and the voice prompts “power off”.

Earphone pairing

1.Under the pairing status, the white-orange light of the primary ear blinks and the light of the secondary ear goes out.

2. After successful pairing, the connected device will be displayed on the cell phone page, the light will go out after successful matching, and the voice prompts “Pairing Successful”.

3. After connecting with the cell phone, the voice prompts “Connected”.

4. Pairing timeout, when powering on without connecting to the cell phone, it automatically shuts off after 3 minutes.

Function operation

Answer the phone: when an incoming call, any double-click on the left and right buttons, the incoming ringtone phone and headset synchronization
Hang up: during the call, any double click on the left and right buttons, maximum and minimum volume beeps.
Volume up and down during the call: click the left and right buttons arbitrarily, add/subtract one level every time you press it, only the volume is added when you use it with one ear.
Listening/Pause: Double-tap on the left or right ear.
Previous/Next song: Long press the left and right buttons for 2 seconds, monaural use only the next song
Volume up/down: click the left and right buttons arbitrarily and add/subtract one level for each press.
Voice assistant: Tap the left or right ear four times in a row, The voice prompts “doo”
Incoming call rejection: press and hold any left or right button for about 2 seconds.
ANC Noise Reduction Mode: 3 consecutive clicks on the left or right ear to enter the pass-through mode; again 3 consecutive clicks on the left or right ear to enter the ANC noise reduction mode. Again 3 clicks off.
one tow two connection mode: in the headset power on state connect the first device successfully, close the device’s bluetooth function, so that the headset to enter the matching state, and then to connect the second device successfully, the first device to open the bluetooth again, manual operation to connect the headset,A tone sounds when the connection is successful.
1Reset the headset: any long press the left and right buttons for about 8 seconds, to reset, reset the successful white-orange light fast flash,Headset goes “beep”.
LED power display: put into the charging compartment, the headset orange light is on for charging status; headset charging orange light is always on; headset is full, the box extinguishes the light, the headset extinguishes the light.

LED indicating status

Put the headset into the charging case, the orange light of the headset will be on, and the white light of the charging case will be on.
Headphones out of the charging case, white and orange lights flash alternately.
Headset pairing, white-orange light blinks in the main ear, and the light goes out in the secondary ear
Headset and cell phone pairing success, headset light off.
Charge the charging box, orange light single flash, full orange light always on.
The headset is put into the charging box to charge, the charging compartment light will be on for a long time, the headset full light will be off, and the box light will be off.

Attention

Do not use abrasive cleaners to clean this product.
Do not allow this product to heat up or be near a source of ignition, such as a cooking stove.
Do not dispose of this product in a fire to avoid explosion.
Do not attempt to disassemble this product to make any modifications as it does not contain any service components.
Do not use this product in the rain.
If you do not intend to use this product for a long period of time, please store it in a dry environment and charge the headset at least once a month to prolong its life and avoid extreme temperatures and dust.
If you do not intend to use this product for a long period of time, please store it in a dry environment and charge the headset at least once a month to prolong its life and avoid extreme temperatures and dust.