Fuxi-H7 Instruction ma

Table of Contents

Headphone Instruction Manual: Fuxi-H7

Specifications

Speaker: Ø40mm
Impedance: 32±15%Ω
Sensitivity: 110±3dB
Frequency Response: 20Hz to 20kHz
Microphone: Ø6.0×2.7mm
Microphone Sensitivity: -42±3dB
Wireless Distance: 10m
Connectivity: 2.4GHz (Type-C+USB) + Wireless + Type-C Audio Cable + 3.5mm Audio Cable
Lithium Battery: 750mAh
Charging Time: About 2 Hours
Charging Method: (Type-C) USB 5V
Low Latency: 28ms
Size: 86 x 173 x 201mm
Weight: 247g
Playback Time:
2.4G Mode: 30H (No Backlight), 20H (Brightest Backlight)
Wireless Mode: 43H (No Backlight), 26H (Brightest Backlight)

Plug in the Type-C cable and press the power switch to turn on the headphones, entering wired mode.
Adjust volume or skip tracks by short/long pressing or double-clicking the volume buttons.
The microphone is on by default. Press the microphone key to toggle it, with voice prompts for status.
Switch between stereo and virtual 7.1 channel by pressing the 7.1 key, with voice prompts indicating mode.

Connect the headphones to a music player using the 3.5mm audio cable to use in wired mode without other functions.

Turn off the headphones and remove the transmitter.
Power on the headphones and enter “Gaming Mode” by double-clicking the power button.
Connect the 2.4G receiver to your device.
The headphones and receiver will automatically pair and indicate successful pairing.

Connect the receiver to your device; indicator lights will flash then remain on when paired.
Similar volume and microphone controls as wired mode.
Switch between stereo and virtual 7.1 sound with a button press and voice prompts.
Low Power Mode: Audible beep every minute when battery voltage drops to 3.30V.
Power Off Mode: Automatic shutdown when battery voltage is below 3.25V or after 10 minutes without sound source.

Power on the headphone and double-click the power button to switch to wireless mode. You will hear a voice prompt: “Wireless mode.” In pairing mode, the indicator will flash, and the voice prompt is “power on”.
The headphone is compatible with most smartphones and other devices that support wireless headphone protocol.
Activate wireless mode on your phone and search for “Fuxi-H7” to initiate pairing.
Click “Fuxi-H7” to pair. Upon successful pairing, a voice prompt will say “connected” and the indicator will remain on. If previously paired, the headphone will automatically connect under wireless mode.

Answer an Incoming Call: Short press the power button. Note: Some phones may default to their own receivers, so refer to your mobile phone’s instructions to adjust settings.
End Current Call: Short press the power button.
Refuse an Incoming Call: Press the power button for 1.5 seconds when there is an incoming call.
Play Music:Play/Pause: Short press the power button.
Previous Song: Double-click “Volume-” to go to the previous song.
Next Song: Double-click “Volume+” to skip to the next song.
Volume+: Short/long press “Volume+” to increase volume.
Volume-: Short/long press “Volume-” to decrease volume. (Refer to the wireless UI for further details.)