Table of Contents
Pulsar X2H v3 Mini Wireless Mouse User Manual
Pulsar X2H v3 Mini Wireless Mouse User Manual
FCC id: 2A2TU-PX2H3ES11
Basic function
Indicator light
Working mode switching
Toggle switch,
- wired mode when moved to the left “X”;
- RF mode when moved to the right “O”
DPI Setting
- Gather Step 1: Press the “DPI” switch to light the OLED, and the OLED will display the current set values;
- Gather Step 2: Press the switch again, set the DPI value, at this time OLED will only display the DPI value, other Settings will be hidden;
- Gather Step 3: After the setting is complete, wait 3 second, OLED will display the current overall setting values;
- Gather Step 4: Wait another 3 second and the OLED will turn off;
DPI sets the step level
400-800-1600-3200-6400-12800
Back and forth cycle
Polling Rate Setting
- Gather Step 1: Press the “HZ” switch to light the OLED, and the OLED will display the current set values;
- Gather Step 2: Press the switch again, set the polling rate value, at this time OLED will only display the polling rate value, other Settings will be hidden;
- Gather Step 3: After the setting is complete, wait 3 second, OLED will display the current overall setting values;
- Gather Step 4: Wait another 3 second and the OLED will turn off;
Wire mode polling rate sets the step level
500Hz-1000Hz-2000HZz-4000HZ-8000HZz
Back and forth cycle
Wireless mode polling rate sets the step level
500Hz-1000Hz-2000Hz-4000HZ
Back and forth cycle
LOD Setting
- Gather Step 1: Press the “HZ” switch to light the OLED, and the OLED will display the current set values;
- Gather Step 2: Hold down the “HZ” switch and set the LOD height value by pressing the right mouse button. At this time, OLED will only display the current LOD set value, and other set values will be hidden;
- Gather Step 3: After the setting is complete, wait 3 second, OLED will display the current overall setting values;
- Gather Step 4: Wait another 3 second and the OLED will turn off;
LOD sets the step level
1Tmm—2mm
Back and forth cycle
Motion Sync Setting
- Gather Step 1: Press the “HZ” switch to light the OLED, and the OLED will display the current set values;
- Gather Step 2: Hold down the “HZ” switch and press the right mouse button to enable or disable the “Motion Sync” function. At this point, the OLED will only display the current set value, and other set values will be hidden;
- Gather Step 3: After the setting is complete, wait 3 second, OLED will display the current overall setting values;
- Gather Step 4: Wait another 3 second and the OLED will turn off;
Motion Sync sets the step level
ON—OFF
Back and forth cycle