Table of Contents

Shenzhen Mgctech Wireless Car Charger User Manual

FCC id: 2AVSB-IC-20CSQ

Product Features

Built-in strong magnets, easier for one-hand operation.
Built-in smart semiconductor chilling plate and cooling fan, the fan will start working when the wireless charging starts,the chilling plate cools the wireless charging coil and the phone surface simultaneously to improve the wireless charging efficiency. The semiconductor chilling plate stops working when the phone is removed.
Standby mode: The RGB light runnning three laps and it keeps green.
Charging mode: The colorful lights of the fan change gradually,the light goes off once removed the receiver.
FOD function: when put metal or magnet objects on the charger, the wireless charging stops working and the phone does not charge.
Perfect protective function based on over-voltage, over-current, over-temperature and short-circuit protection.

Product Operating Guide

Please make sure the product connect to the power before using.
The product stop charging when the current is too large or there is foreign object. Do not wireless charging the phone if similar situation happened.
Please purchase the wireless receiver module or case separately (Not included in the product) if your phone do not support wireless charging.
The power input is 5V-12V, when placed the phone and wireless charging starts, the chilling plate works and the fan rotates. When the phone is removed, the chilling plate stops working and the fan stops rotating 30 seconds later.
It is recommended to use phone case less than 2mm thick. The product cools the phone backside surface too thickness phone case will affect the cooling effect.

Product Parts Description

Parts List

Charging Transmitter Coil
Magnet
RGB Light
Electronic Refrigeration
PCB
Type-C Charging Port
Cooling Fan
Knob
Vent Clip

Specifications

Input	DC 9V/3A, 5V/3A
Output	15W/5W
Product Standard	Qi2
Charging Distance	<10mm
Charging Efficiency	<80%
Product Dimension	71.74571.7mm
Product Material	ABS+Tempered Glass

Fast wireless charging requires QC or PD adapters.

Attention :

Please do not vigorously extrude or collide.
Please do not dismantle or put it into fire or water when the product is power on,to avoid short circuit or leakage.
Please do not use it in severely high temperature, high humidity or corrosive environment, to avoid damage to the circuit leakage
Please do not put the magnetic strip or chip card (Such as ID card,bankcard etc.)on the charging pad to avoid to cause magneticcard lose efficacy.
Please do not put the metal (Such as coin etc.) on the charging pad when charging, to avoid damage from heating.

Note: This product is applicable to all Qi standard wireless charging phones,other phones need an external receiver for wireless charging function.