Stylus Open Ear Headphones User Manual

Stylus Open Ear Headphones User Manual

FCC: 2BFT2-KESAIYIS8L

Product Specifications

• BT version: JL5.3
• Drive unit: @13.5MM
• Impedance: 32ohm £15%
• Grade of Waterproof: IPX 4
• MIC: 2718 Silicone microphone
• Earphone Battery: 30mAH, IC with protection board;
• Earbuds battery: 200mAH, with protection board;
• Earphone charge time: 1H :
• Earbuds charge time: 1.5Hs (4 times for earphone)
• Distance: >10M (barrier free)
• Playing time: 5-6Hs
• Charge Port: Type-c

Operating instruction

1. The music play/pause: click on either side
2. Double click on the left ear add volume
3. Double click on the right ear reduce volume
4. Answer/hang up/reject : click on either side
5. Phone call voice remind
6. Power tips
7. Long press on the left ear: last song
8. Long press the right ear :next song
9. Three strike any ear: Siri voice assistant

Power indicator

About Turn on/off:

Long touch the power button to turn on the earphone,and the indicator light will flash.

Then long touch the power button to turn off the earphone the light off.

Power off Long touch the power off button until led in red . when not use, the bluetooth device enter off mode or you just put the earbuds into the charge box , the earbuds will power off.

About Charging:

‘When the earphone is charging, the indicator light is always on, the light will off when full power.

About pairing :

Take the earbuds from the charger box, the led flashing in red and blue alternately automatically, left and right side will pair successfully when the led flashing in red and blue slowly .turn on the bluetooth on your device and connect it . the device will pair automatically within about 5 seconds ,.when pair successfully , light off.

Tap 3 times to switch siri

Long press the touch surface to turn on and off the earbuds.

When earphone is not connected to the phone, it will automatically turn off after 5 minutes.

• charge the earphones, please put them in the charging case and close the cover.
• charge the charging case, please use the included USB cable and plug itinto the USB power supply for charging

When the charging box is fully charged, the earphone can be fully charged for 3 additional times

Troubleshooting

1. Make sure the charging case is full of power
2. Put the earbuds to the case to charge for a while
3. Take the earphones out of the case till the red and led light flash alternately, this method is only applicable when the left and right earbuds can’t pair to the device
4. Connection failed,check whether the earbuds are paired or not ,turn off other bluetooth device
5. Low sound volume or distortion of sound, check the volume of bluetooth device, and turnit tothe proper volume
6. The earphones should be used correctly according to the requirements, in order to ensure smooth connection,pay attention to the influence of the use environment on the earphone.ltis suggested that the distance between the cellphone and the earphones should be within 10M.

Safety Tips

Charge.

Charge in the case.

The charging compartment uses the TYPE-C port to charge.

PDF