2815-006 Remote Control User Manual – Model 815A

1. User Operating Instructions

1.1 Manual BLE Pairing

1. Press the home and back buttons for 3 seconds to begin the pairing process, indicated by continuous green LED flashing.
2. If pairing is successful, LED stops flashing green.
3. To delete pairing, press home and left buttons for 3 seconds. Successful deletion is indicated by the LED flashing red 4 times.

1.2 LED Behavior

1. Green LED flash: STB connected via BLE, BLE command transmitted.
2. Red LED flash: Remote IR command being transmitted.

1.3 TV Programming

1. Press OK button for 3 seconds to start BLE configuration mode for the ruwido direct app.

1.4 Switch Transmitting Mode

1. Press home and up buttons for 3 seconds to activate BLE+IR mode.
2. Press home and down buttons for 3 seconds to activate IR only mode. Successful programming is indicated by the LED flashing twice.

1.5 Factory Reset

1. For factory reset, press and hold the home and mute buttons for at least 3 seconds. Successful reset is indicated by the LED flashing red 4 times.

2. Declaration

User Information FCC 15.21:

Changes or modifications not expressly approved by the responsible party could void the user’s authority to operate the equipment.

Part 15 Statement According to FCC 15.19:

This device complies with Part 15 of the FCC rules. Operation is subject to two conditions:

1. (1) This device may not cause interference.
2. (2) This device must accept any interference, including interference that may cause undesired operation.

Statement RSS GEN Issue 5:

This device contains licence-exempt transmitter(s)/receiver(s) compliant with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to two conditions:

1. (1) This device may not cause interference.
2. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Ce dispositif contient des émetteurs/récepteurs exemptés de licence conformes aux RSS d’Innovation, Science et Développement Économique Canada. Le fonctionnement est soumis aux deux conditions suivantes:

1. (1) Cet appareil ne doit pas causer d’interférences.
2. (2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable de l’appareil.

 

PDF

xyn815a_usersmanual_7877675_27e730d90b